Jump to content

Search the Community

Showing results for tags 'Dual Loop'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • Thermaltake
    • Enthusiasts
    • Chassis
    • Power Supplies
    • Cooling
    • Storage
    • Accessories
    • General Discussion
    • Events
    • FAQ
  • Tt eSPORTS
    • Tt eSPORTS PLUS+ Community & Data Management Platform
    • Gaming Mice
    • Gaming Keyboards
    • Gaming Headsets
    • Gaming Controller
    • Gaming Mouse Pads
    • Gaming Accessories
    • Team Tt eSPORTS
    • Tt eSPORTS Streamers
    • Gaming Chair & Gaming Station
    • Tt eSPORTS General Discussion
    • Tt eSPORTS Events
    • Tt eSPORTS FAQ
  • LUXA2 Thermaltake Mobile
    • Power Bank Solution
    • Holder Solution
    • Audio Solution
    • Accessories
    • LUXA2 General Discussion
    • FAQ
  • Others
    • Off Topic
    • Customer Service

Categories

  • Thermaltake
  • Tt eSPORTS
  • LUXA2
  • Others

Calendars

  • Community Calendar

Blogs

  • Thermaltake
  • LUXA2
  • Tt eSPORTS

Found 1 result

  1. Hi Guy's I am new to this forum. I have started a new project (no name) in the x71 case. I am going to be modding the front of the case and adding temper glass. It will have a dual loop two pumps two Res and two 360 rads, I am looking at replacing the motherboard tray and add my own plus a few little surprise a long the way. Also going to we extending and sleeving all cables. Components. CPU: i7 4770K overclock to 4.6 RAM: Corsair vengeance Ram 16gb GPU: Zotec 980ti PSU: Corsair ax 860 WATERBLOCKS: EK 2x Pump: EK d5 2x RAD: EK 360 FANS: 7x 120 Riing 12 thermaltake RGB FANS: 3x 140 Riing 14 thermaltake RGB FITTINGS : Thermaltake pacific petg 16mm compression. FITTINGS : 3x EK pass through HARD TUBE: Thermaltake Petg 16mm Here are some early drawings X71 case Some of the components. Was not sure if I should use 2x 140 or 3x 120 fans still not sure what do you think? I like to draw out what I want to do and I took size for new motherboard tray. I did draw up some designs for new air intakes then got them laser cut. I had to cut some of the front case for them to fit. These are removable not sure if I am going to leave them clear or paint them. This weekend I am hoping to drill out the rivets and start the motherboard tray. Sleeve the pumps and front panel connectors. Thanks for check out my mod any question or feedback let me know below.
×