Everything posted by JackDoff
Suggestions (or am I missing something?) When iTake loads at system startup, hide your obnoxious logo. It's only a mouse pad. I don't need your flashing logo every boot. Can I save the RGB preset to the mouse pad? Then I would not need the software to load at all unless I want to change the colors. Every other RGB device I have does this. Once saved to the device it uses that config immediately after the PC is turned on. For the mouse pad it has to sit there rainbow cycling until I login, then your software loads, then it decides to finally show the profile I setup. Can I change the logo display? Can I store the profile?
Fixed. I needed the iTake software instead of the TT RGB Plus software. iTake found the mousepad and allowed me to change settings.
Hello, I just bought the Level 20 RGB Extended Gaming Mouse Pad (Part no GMP-LVT-RGBSXS-01). I downloaded the TT RGB Plus software from here https://www.thermaltake.com.au/downloads and installed it. Launch the software and it complains about not detecting any fan controller. I only have the mouse pad. Don't care about fan controller. Cannot close the error message. I can click behind the error, so got rid of the fan profiles and found the mouse pad detected (see attached), but I can only set it to "Sync on" or "Sync off". What are they supposed to do? How do I change colors? It seems as if some settings took place because originally the pad was cycling RGB colors, now it is just fixed purple color. How do I change the colors? Thanks for any help.