Daz

https://www.facebook.com/pas.naomy/videos/1025758950841082/ How did you go about doing this in the end? I am guessing that you didn't wait for the cable from Thermaltake

I would guess it to be the middle pin.

Quoted from karel1710 on the audrino.cc forum: "The pins are like this : (from left to right) 1 - speed (high low) 2 - stop/start (when the rgb loop is running) 3 - switch between the 4 predefined colours 4 - seems to be ground 5 - haven't found out yet" I have since used this info and modified my rig. The functions of my two controllers can now be activated (in sync) by the press of a button, located on the front panel of my H15 case. FYI - the spare 5 pin connector uses a Mini JST 2.0 socket. I used this to tap into the controller http://www.ebay.co.uk/itm/321879095200?_trksid=p2057872.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT ...and these are the buttons i used http://www.ebay.co.uk/itm/281903401655?_trksid=p2057872.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT

I have just built my old system into a H15 windowed case, adding 3 RGB fans and soon to be fitting a Water 3.0 120mm system. A few questions from the newbie: Where in the case would be best to fit the 120mm Water 3.0 radiator? Keeping in mind that i also want to have my air cooled EVGA GTX970 running as cool as can be. Are there any top vent dust filters that i can buy specifically for this case? When are Thermaltake going to do away with the 1990-esque Riing controller and introduce software controlled fans via the usb header? (The H15 just doesnt have the space for the current system, also removing the covers to change fan speed and such is ridiculous!. But they look cool, so i will let that slide for now...