cbidwell91 Posted January 14, 2021 Report Share Posted January 14, 2021 Hello Everyone, New to the community and custom water cooling in general. I recently picked up the Core P90 with plans to go custom cooling. I've seen good results with a push/pull radiator in my old case and was hoping to carry a similar setup over to the new chassis. Using a 420-480MM radiator, is it possible to do a push/pull setup with the factory hardware? I've found a custom build where someone mounted the radiator vertically, but by its side. Thermaltake advised this is custom. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.