AlphaStealth Posted July 20, 2018 Report Share Posted July 20, 2018 I have a Thermaltake Core X9 case with a four fan (push/pull) Thermaltake Floe Riing RGB 280 TT Premium Edition Water Cooling System, 6 additional Thermaltake Riing Plus 140mm RGB fans (Serving as case fans), One Thermaltake Riing Plus 20 RGB Case Fan, 3 Riing Plus RGB controllers and a Thermaltake Toughpower iRGB Plus 1250W Titanium PSU. Everything is setup and working fine with the exception of syncing the PSU to the rest of the RGB system (I have a support request into Thermaltake on that issue). Now I want to clean up the install and that requires fan cable extensions to allow for the controllers to be located where I want them in the case (they are hanging in free air in the right front part of the case and it looks bad. So, who makes compatible fan extension cables for the 9 pin thermaltake Riing Plus RGB fans? Thanks AlphaStealthHWSW Quote Link to comment Share on other sites More sharing options...
Tack Posted July 20, 2018 Report Share Posted July 20, 2018 A internal usb header extension will work. I had to do the same for my core x9 but have not finished as I am abandoning the x9 project and preparing for the Level 20 XT. Or you can make your own as they are just dupont connectors. I have gone both routes but the time as cost of making you own is far greater then buying some from a reputable China seller. Plus making your own is just a hair puller as its hard to get it just perfect. Now as for AWG the fans are 26AWG and all I could find on ebay that was the same or larger was 24AWG. The ebay seller I went with was https://www.ebay.com/itm/382476740228?ViewItem=&item=382476740228 They shipped it right away but it did take about 20 days to get to me on the west coast but that is to be expected with a China epacket. I plan to sleeve them once I get the level 20 xt and pick a theme as its a beauty http://computex2018.thermaltake.com/goods_key_chassis.html And yes they are 8 pin as that is all the fan need to do everything. The cables I bought I have tested and running for over 2 months now. Quote Link to comment Share on other sites More sharing options...
melindalucy Posted January 13, 2021 Report Share Posted January 13, 2021 On 7/20/2018 at 6:05 PM, Tack said: A internal usb header extension will work. I had to do the same for my core x9 but have not finished as I am abandoning the x9 project and preparing for the Level 20 XT. Or you can make your own as they are just dupont connectors. I have gone both routes but the time as cost of making you own is far greater then buying some from a reputable China seller. Plus making your own is just a hair, puller as its hard to get it just perfect. Now as for AWG the fans are 26AWG and all I could find on ebay that was the same or larger was 24AWG. The ebay seller I went with was https://www.ebay.com/itm/382476740228?ViewItem=&item=382476740228 They shipped it right away but it did take about 20 days to get to me on the west coast but that is to be expected with a China epacket. I plan to sleeve them once I get the level 20 xt and pick a theme as its a beauty http://computex2018.thermaltake.com/goods_key_chassis.html And yes they are 8 pin as that is all the fan need to do everything. The cables I bought I have tested and running for over 2 months now. Looks very complicated Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.