Jump to content
Sign in to follow this  
Thermaltake Admin

Share your ideas - Mandrels 3D Design from Joey Gentry

Recommended Posts

Thanks for Mandrels 3D Design from Joey Gentry!

 

Name: Joey Gentry

90Mandrels Description:
The 90Mandrels file is a Mandrel for bending a 12mm hard tubing (acrylic or PETG) 90 degrees. The mandrel support holding the entire 12mm tubing perfectly because they are 12mm deep. This allows you to use several of them to attach to a board and setup an entire tube. This is very similar to the monsoon kit but with my design they allow you to bend tubes in 90 degree offsets of each other because the mandrel wraps the entire tube.

Mandrel-90.jpg

 

45Mandrels Description:
The 45Mandrels file is a Mandrel for bending a 12mm hard tubing (acrylic or PETG) 45 degrees. The mandrel support holding the entire 12mm tubing perfectly because they are 12mm deep. This allows you to use several of them to attach to a board and setup an entire tube. This is very similar to the monsoon kit but with my design they allow you to bend tubes in 45 degree offsets of each other because the mandrel wraps the entire tube.

Mandrel-45.jpg

 

Share your ideas now! http://3dmakers.thermaltake.com/downloadMaker.aspx 

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

Sign in to follow this  

×