I have the following setup:
ThermalTake Level 20 MT ARGB Mid Tower Chassis Case
Gigabyte B360M AORUS Gaming 3 Intel 8th Gen Motherboard
The current setup is that the ThermalTake LED controller board controls all three fans on the front of the case, and I believe these are digital LED fans, and the only way to control the fan colours is by pressing the RGB switch at the top of the case. I've found out that I can hold this switch for 3 seconds and it is supposed to switch over to software control, but since it's not connected to the motherboard, the fan LEDs are off.
My motherboard supports both analog LED (12V, GRBW) and digital LED (VDG), I was wondering if I could plug the TT LED control board into the motherboard, and if so, how does it connect up? I cannot find a wiring diagram for this board. There is a COM1 connector with a hard-wired cable going into a SATA power connector from the power supply.
I've attached a picture of the LED control board.