Ausar 0 Posted June 5, 2020 Report Share Posted June 5, 2020 Can anyone help me figure this out? I am able to control some of my case fans RGB through the TT RGB Plus software flawlessly, but four are stuck on default. I have two controllers connected and the dip switch set to 1000 and 0000 on the other. Quote Link to post Share on other sites
Tack 55 Posted June 5, 2020 Report Share Posted June 5, 2020 Are the four that are not working on the same controller? Quote Link to post Share on other sites
Ausar 0 Posted June 6, 2020 Author Report Share Posted June 6, 2020 (edited) 7 hours ago, Tack said: Are the four that are not working on the same controller? Sorry for the long delay in response. Now that I've come home after changing the dip switch on one of the controllers, all fans RGB are now working. However, the tt software now says a controler one, and the only way to make it work is switch to another profile. Right now it is on Lumi Plus Edit: Scratch that after a restart everything went back to not all working Edited June 6, 2020 by Ausar Quote Link to post Share on other sites
Tack 55 Posted June 6, 2020 Report Share Posted June 6, 2020 so it was working fine but then after restart it went back to not working? can you take a pic of how its hooked up and a screenshot of the tt rgb software. what are your system spec? Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.