EATX DRAMA!!
So I was drawn in by the sweet pictures of this case and did a lot of research to see if this would be a good fit for my incoming EATX Rampage VI board
After ripping everything out of my V51 case and fitting mobo into the View 71 I discovered that its not the best for EATX. I currently have the Rampge IV Black edition.
The holes for running cables through to back of case are UNDER the edge of the extended board. I can't believe I missed this when researching.
Usually I run the 24 pin through to the back to reduce cabling, but now I have to run all cables on mobo side of inner case. So annoyed.
The Specs on the TT site state it is EATX compatible, but this is a fail.
See attached pic
