Arby

And the results: Radiator fans off. Coolant pump running between 350-500 RPM Reservoir coolant down to -2F Zero condensing. Ryzen 2700X peaking at 4.5GHz EVGA 2080 did very well also.

Finishing up... Found that the Thermaltake V1 case barely fits all the components. Actually had to un-rivet the case and reassemble it back around the components. Dropping the thermostat temp a little each day to find the condensing point. Today with the transfer coolant at 28F the GPU runs at 57F. Other than the refrigerant lines and internal coolant hoses, nothing else is insulated. 2 pumps in series, first pushes the coolant through the heat exchanger and the second through the system. Turning on the radiator fans actually reheats the coolant so when I am running the cooler I shut the fans off. one of the V1 sides has a clear plastic panel so I put down the Thermaltake dragon, sprayed it then pulled the stencil back off. Still need to put an RGB defused light behind it.

Just started on this last night. A small compact chiller that runs off of 120 household AC. To keep the coolant from freezing I am testing with 50% methanol / 50% water that I use in my cars injection system. Methanol being very corrosive will not be the coolant of choice in the finished product. 12 minutes later after turning off and it is still -15.

Installed the Asus 1200 watt PSU and prefer to place it sideways as the P3 case does. Contacted TT but no reply how to aquire the brackets :-(

With no luck finding the brackets, I went a different route. Maybe easier and cleaner. I removed 4 screws off the top of the PSU and installed nylon stand-offs. Mounted under the expansion card mount.