Jump to content
  • Forum Statistics

    6,314
    Total Topics
    42,276
    Total Posts
  • Member Statistics

    73,884
    Total Members
    16,800
    Most Online
    Meek Leonardo
    Newest Member
    Meek Leonardo
    Joined

cbidwell91

Members
  • Content Count

    2
  • Joined

  • Last visited

About cbidwell91

  • Rank
    Beginner

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. I have a Corsair H100i and I am able to the AIO on my P90 setup. It is TIGHT and not ideal, imo. I have the rad mounted with the hoses at the bottom so the top portion of the radiator is higher than the CPU. Let me know if you'd like a photo. Parts I'm using: Corsair h100i AIO Asus Z-390 Tuf Gaming Plus Wifi MB i9 9900k CPU g.skill DDR4 memory
  2. Hello Everyone, New to the community and custom water cooling in general. I recently picked up the Core P90 with plans to go custom cooling. I've seen good results with a push/pull radiator in my old case and was hoping to carry a similar setup over to the new chassis. Using a 420-480MM radiator, is it possible to do a push/pull setup with the factory hardware? I've found a custom build where someone mounted the radiator vertically, but by its side. Thermaltake advised this is custom.
×
×
  • Create New...