Jump to content

Floe Riing 360 Help.


Kernun Enta
 Share

Recommended Posts

I am installing the Floe Riing 360 onto a z390 Aorus Xtreme utilizing an 1151 platform. The rear bracket, with standoffs in place, is very loose. The pads are also against some solder pins. Is this cooler incompatible with this board? Will the rear bracket sinch up when I install the pump? Should I even use this cooler with the pads touching the solder pins?

Link to comment
Share on other sites

You use the original backplate which came with your mobo? - this is important!

No worries when the backplate fits loose.. once you mount the cooler head the mount pressure, when fastening the 4 screws, will pull it tight in place.If there is contact with solder pins use tape to isolate the standoff where needed

 

 

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
 Share

×
×
  • Create New...