Jump to content

Recommended Posts

Posted

I've been working on a TT Tower 900 build, but on starting up the various top LEDs and buttoms aren't working (power, reset, HDD LED, power LED). I can only think that when I removed the cable ends to resleeve it I replaced them in the wrong order - not very clever. Does anyone know the cable order so I can redo them?

Thanks

 

 

file-1.jpeg

  • 5 years later...
Posted
On 6/15/2019 at 7:27 PM, Spyshark said:

I've been working on a TT Tower 900 build, but on starting up the various top LEDs and buttoms aren't working (power, reset, HDD LED, power LED). I can only think that when I removed the cable ends to resleeve it I replaced them in the wrong order - not very clever. Does anyone know the cable order so I can redo them?

Thanks

 

geometry dash breeze is wonderful.

file-1.jpeg

I think the power switch cable usually consists of two wires. To connect it correctly, locate the pins labeled as "PWR_SW" or something similar on the motherboard. The positive (+) and negative (-) pins should be marked on the motherboard or in the motherboard manual. Connect the power switch cable to these pins.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...