ok so, im looking to buy a core P8. there is a measurement i need, iv got some assumptions made as to it but i really would like a confirmation if possible before i pull the trigger..
i need to know how long the PSU slot is on this beasty.
i know TT says 200mm max length, BUT according to all the images a 225 should fit.
going off the attached picture, the orange lines are in line where the ATX motherboard screws go. the total board width of ATX is 244mm, so if we were to shave even some off that as the boards overhang a little..... (actually just measured and got 230mm between screw holes)
kinda hoping someone has one of these cases at home they can put a tape measure in to measure from the bracket for PSU at maximum length position to the edge of the grommet. (the blue line marked)
Thanks in advance peeps