Jump to content

Core P90 Push/Pull Radiator Setup


Recommended Posts

Hello Everyone, 

New to the community and custom water cooling in general. I recently picked up the Core P90 with plans to go custom cooling. I've seen good results with a push/pull radiator in my old case and was hoping to carry a similar setup over to the new chassis. Using a 420-480MM radiator, is it possible to do a push/pull setup with the factory hardware? I've found a custom build where someone mounted the radiator vertically, but by its side. Thermaltake advised this is custom.  

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • Create New...