Jump to content

Recommended Posts

Posted

Hi,

Make sure the tubes are pressed in all the way on the fittings. Did you by any chance take out the color insert rings that go on both ends? They have  to be there for it to spin.

Depending on your tube work, if the flow2 is being pushed or "tweaked" and not "straight" just try to shift it around a little bit and it should be fine.

Also check to see if there is anything that is trapped in there or loose. You might want to partial drain the system, take it out and give it a look to be sure.

Keep us posted, I have personally used this product a lot on builds, i have not had many issues.

  • 4 months later...
Posted

Hello,

I recently put this into my custom loop but it wont spin(with d5 pump at max) if I tap it it slowly spins then stop and repeates for about a minute before coming to a complete stop again, 

Why is it doing this?

Thanks 

20180611_112538.jpg

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...