Hippomedon

Hi,
First off, when you get the alert message, make sure to click ok to close it.
Then, there is likely a port empty, which the software will alert you that nothing is detected.
Click that blue circle on that port in the software to turn it red (Disabled) if nothing is on that port and the software will stop alerting you about it.
As for the changes and saving, make sure each controller is on the right profile, they can all be different as well.
Check your connections too.
 

The riing plus controller run via usb and doesn't require any rgb header. 
 
The TT sync controller does require a rgb header.
 
As for another controller give support a call I am sure they can hook you up.

Hi,
Did you set the dip switch to like #2? both controllers cant be on #1 or it wont show up.
About the daisy chain stuff, you can use either of the 2 connections from the USB header Y cable and anything after that will use the link cable.
You can plug in #1 controller to the cable from the USB header on the motherboard and then link with the daisy chain cable for #2 as well.
Either or dont matter, all that does matter is the dip switch to assign the controller #1-16