Chiobe Posted February 19, 2015 Author Report Posted February 19, 2015 Things are coming along nicely. I'm just lacking hard drives and PSU in bottom now. Plus some more cable management. Quote
Chiobe Posted February 19, 2015 Author Report Posted February 19, 2015 Yet another problem. This time so was it the top GPU that didnt fit. Turns out the RAM brakets had these plast bits on the side. Most of them where already gone, so I removed the last 2. Finally so is it mounted right. And this is how things looks so far. Quote
Chiobe Posted February 20, 2015 Author Report Posted February 20, 2015 Cable management is done for everything, extept the top rads. Also, everything thing else is installed, so I will start tubing after installing the top rads. Quote
Chiobe Posted February 20, 2015 Author Report Posted February 20, 2015 The system is now filled and is bleeding. There was a few leaks, thanks to the EK logo plugs didnt seal properly. But after replacing them, so does it seem fine. Quote
Chiobe Posted February 22, 2015 Author Report Posted February 22, 2015 Okay, the pc is finally up and running. So far so does this seem to be the idle temptratues: Quote
Chiobe Posted February 22, 2015 Author Report Posted February 22, 2015 Okay, first problem has shown it self: My fan controller has died So it will be a bit longer before this build is fully up and running. Quote
Chiobe Posted February 22, 2015 Author Report Posted February 22, 2015 At least 1 good thing has come out of the whole deal with the fan contoller, I have been able to check my idle temps with no fans running: Quote
Chiobe Posted February 26, 2015 Author Report Posted February 26, 2015 I have had to of cource import an new fan controller, so it will take a bit longer then planned to get this pc up and running.Lamptron CF525 Fan Controller (http://www.lamptron.com/product/controllers/cf525/), is the one I getting this time and it should be more then powerfull enough for my setup. Also, I managed to find the flash for my camera, so you guys can get a look at its full quality: Quote
Chiobe Posted March 7, 2015 Author Report Posted March 7, 2015 My case is finally done, for this round.Once I get some free money again, so will I do some more, as there are a few things I still want to do better. ThermalMike and Tt Andy 2 Quote
skline00 Posted March 18, 2015 Report Posted March 18, 2015 Nice job! I used two XSPC RX480s on the top with AP15 GT fans and mounted the EK Coolstream 480 PE on the right side looking at the front with the radiator mounted on the floor (used one of the HDD brackets. Since I'm using the XSPC Twin D5 Bay/Res with 2 D5s in series that I had used in another build I mounted it on the left front side with the supply flowing into the EK rad. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.