Leaderboard

Hi All, With another weekly update here. I am quite behind schedule so I will speed up my work in the coming too weeks. Expect lot more photos and progress within the month of November. So once the 3D prints for the two radiator fan grills for two 480mm radiators were finished, I glued the pieces together and brushed on some filler. Tried our sanding the parts down but it seems I need to do a patch up job for some parts. For printing these parts i tried octoprint with raspberry pi (old model) I think because of the slow CPU, some parts came out very rough and unfinished. so that means more sanding for me 😢 I cut the top mounting piece of the fan to check whether I can further integrate the grill closer to the fans and as one piece. I will make the decision on whether to do this or not as we proceed. What do you guys think? Attached are the picture of this week peace V

some photos, geometry of the future project.

Hello again. Still progressing :) Because I have the fans pulling air in form the back of the case to make real use of the dust filter. I made some new stickers for the backs of the fans to make them still look like the front.. Building the base is a messy but fun. A lot a carving to be done. And dino's to make and fit to the base. Above I used Cling_wrap to cover the parts. to keep them clean.